Page 1 of 1

Remote Mode @ power up on HAL104

PostPosted: Wed Aug 24, 2016 11:33 am
by Martin Oakley
Hi,

Is there a way to set HAL104 to Remote Mode at power up?

Re: Remote Mode @ power up on HAL104

PostPosted: Thu Aug 25, 2016 3:41 pm
by Amy Lyons
Hi Martin

To set the HAL to start up in remote mode please follow the below instructions:

From the 'Main Menu' select 'Setup' and press the 'Start' key
Select 'Edit User List/Options and press the 'Start' key
Select the relevant user from the list and press 'User Settings'
Select 'Start Up' and press the 'Start key until 'Remote Mode' is displayed
Press OK
Press the 'Reset' key and the screen will read 'Storing System data'

Next time you turn the tester on it should start up in remote mode