Page 1 of 1

Shorter Test n Tag label

PostPosted: Wed Mar 05, 2014 5:46 pm
by Agro
I have a K3100. I am continualy cutting off with scissors about 25mm of yellow tape and throwing it away. This is where the company logo is supposed to be, but I don't use the company logo as I find that with the extra 25mm it is too large to fit in a discrete place.
Is it possible for me to make the label shorter?

Re: Shorter Test n Tag label

PostPosted: Fri Mar 28, 2014 12:43 pm
by Graeme
I have the same problem. Some frugal peolple have advised, at the end of the roll, turn it around and re feed, thus using the other half of the label.
Short of this, there is no answer I can see.
Graeme

Re: Shorter Test n Tag label

PostPosted: Fri Jun 13, 2014 2:48 pm
by Amy Lyons
Hi Agro & Graeme

This area of the label is reserved for you to add a company logo. Unfortunately the printer does not distinguish if there is a logo there or not and prints the label in this place anyway.
With our new printer ranges we have introduced smaller label types and we will continue to look for more economic labelling solutions.