When we test Microwave ovens we do two tests - one is PAT and the other is Microwave Leakage. These are set up as two different tests on our machines (Primetest 350s) and results are stored under the same asset number. After downloading to PatGuard Elite and creating reports, only one test is showing. Because the Microwave Leakage test is done last, this is the one that shows up on the reports. As well as not being able to see the PAT test results, the test count is not right so we cannot bill the customer for the second test. I could always add the Microwave Leakage onto the end of a standard PAT program, but then I would only end up with one test, so would effectively be doing a microwave leakage test for free.
There is the added problem that one Microwave that we tested failed (damage to the flex) and then later passed after the customer had repaired it and we re-tested. Ideally I would like to be able to charge him (in this case) for three tests. The initial test that failed, the subsequent retest that passed, and the microwave leakage test. So I would like all three tests to display in the reports.
Does anyone know of a way to get all three test results showing in the reports? I usually use the 'Concise Latest Test Results' report and the 'Detailed Latest Test Results' reports.