Just started to use my scanner for annual re-test and had just tested a 4way ext. lead, before scanning the PC next to it. I scanned the bar code and tester went to default sequence on the screen. Just about to press test, and looking at the test it was going to do and saw 25Amp current times 4 highlighted from the previous test.
It had accepted my new ID number for the PC but was going to test it as a 4way ext lead!
Thinking that I had tested the PC incorrectly last year I proceeded to re-test both items again, from new, with new lables, but the same thing happened. The scanner should set up all the tests for each individual items once you have done the initial test, should'nt it?
Any ideas please?