Page 1 of 1

You are not using the default comms settings for the selecte

PostPosted: Tue Mar 25, 2014 5:12 am
by verstapp
so what are the default comms settings for a PT300?
I currently have 57600bps, 8 data, no parity, one stop, most copied from my supernova.
it generally transfers anyway after a couple of tries, but it would be nice not to get the error message every time.

Re: You are not using the default comms settings for the sel

PostPosted: Thu May 01, 2014 9:22 am
by Stephen Armstrong
Thank you for your enquiry and sorry for the delay in replying

For help downloading the PT300, please see the following links (note this is for the PT300 and PT350)

PATGuard 3:
http://www.seaward.co.uk/downloads/041_downloading_a_primetest_3xx_into_patguard_3_v1.pdf

PATGuard 2:
http://www.seaward.co.uk/downloads/007-how-do-I-download-my-PrimeTest-3xx.pdf


The general set-up is:
Bits per second: 57600
Data bits: 8
Parity: None
Stop bits: 2

However, this is not set in stone, for example the bits per second can be changed – but the instrument and software should be set the same.

Kind regards
Technical Support

Re: You are not using the default comms settings for the sel

PostPosted: Thu May 22, 2014 5:17 am
by verstapp
Thanks, Stephen. That got rid of the error message.